A) 1.91 years
B) 2.12 years
C) 2.36 years
D) 2.59 years
E) 2.85 years
Correct Answer
verified
Multiple Choice
A) It will accept too many short-term projects and reject too many long-term projects (as judged by the NPV) .
B) It will accept too many long-term projects and reject too many short-term projects (as judged by the NPV) .
C) The firm will accept too many projects in all economic states because a 4-year payback is too low.
D) The firm will accept too few projects in all economic states because a 4-year payback is too high.
E) If the 4-year payback results in accepting just the right set of projects under average economic conditions, then this payback will result in too few long-term projects when the economy is weak.
Correct Answer
verified
Multiple Choice
A) If the WACC is 10%, both projects will have positive NPVs.
B) If the WACC is 6%, Project S will have the higher NPV.
C) If the WACC is 13%, Project S will have the lower NPV.
D) If the WACC is 10%, both projects will have a negative NPV.
E) Project S's NPV is more sensitive to changes in WACC than Project L's.
Correct Answer
verified
Multiple Choice
A) 14.05%
B) 15.61%
C) 17.34%
D) 19.27%
E) 21.20%
Correct Answer
verified
Multiple Choice
A) The longer a project's payback period, the more desirable the project is normally considered to be by this criterion.
B) One drawback of the payback criterion for evaluating projects is that this method does not properly account for the time value of money.
C) If a project's payback is positive, then the project should be rejected because it must have a negative NPV.
D) The regular payback ignores cash flows beyond the payback period, but the discounted payback method overcomes this problem.
E) If a company uses the same payback requirement to evaluate all projects, say it requires a payback of 4 years or less, then the company will tend to reject projects with relatively short lives and accept long-lived projects, and this will cause its risk to increase over time.
Correct Answer
verified
True/False
Correct Answer
verified
Multiple Choice
A) For a project to have more than one IRR, then both IRRs must be greater than the WACC.
B) If two projects are mutually exclusive, then they are likely to have multiple IRRs.
C) If a project is independent, then it cannot have multiple IRRs.
D) Multiple IRRs can only occur if the signs of the cash flows change more than once.
E) If a project has two IRRs, then the smaller one is the one that is most relevant, and it should be accepted and relied upon.
Correct Answer
verified
Multiple Choice
A) One defect of the IRR method is that it does not take account of cash flows over a project's full life.
B) One defect of the IRR method is that it does not take account of the time value of money.
C) One defect of the IRR method is that it does not take account of the cost of capital.
D) One defect of the IRR method is that it values a dollar received today the same as a dollar that will not be received until sometime in the future.
E) One defect of the IRR method is that it assumes that the cash flows to be received from a project can be reinvested at the IRR itself, and that assumption is often not valid.
Correct Answer
verified
Multiple Choice
A) $138.10
B) $149.21
C) $160.31
D) $171.42
E) $182.52
Correct Answer
verified
Multiple Choice
A) Lacks an objective, market-determined benchmark for making decisions.
B) Ignores cash flows beyond the payback period.
C) Does not directly account for the time value of money.
D) Does not provide any indication regarding a project's liquidity or risk.
E) Does not take account of differences in size among projects.
Correct Answer
verified
Multiple Choice
A) A project's NPV is found by compounding the cash inflows at the IRR to find the terminal value (TV) , then discounting the TV at the WACC.
B) The lower the WACC used to calculate it, the lower the calculated NPV will be.
C) If a project's NPV is less than zero, then its IRR must be less than the WACC.
D) If a project's NPV is greater than zero, then its IRR must be less than zero.
E) The NPV of a relatively low-risk project should be found using a relatively high WACC.
Correct Answer
verified
Multiple Choice
A) 12.55%
B) 13.21%
C) 13.87%
D) 14.56%
E) 15.29%
Correct Answer
verified
Multiple Choice
A) 13.42%
B) 14.91%
C) 16.56%
D) 18.22%
E) 20.04%
Correct Answer
verified
Multiple Choice
A) −$59.03
B) −$56.08
C) −$53.27
D) −$50.61
E) −$48.08
Correct Answer
verified
True/False
Correct Answer
verified
Multiple Choice
A) $77.49
B) $81.56
C) $85.86
D) $90.15
E) $94.66
Correct Answer
verified
Multiple Choice
A) The MIRR and NPV decision criteria can never conflict.
B) The IRR method can never be subject to the multiple IRR problem, while the MIRR method can be.
C) One reason some people prefer the MIRR to the regular IRR is that the MIRR is based on a generally more reasonable reinvestment rate assumption.
D) The higher the WACC, the shorter the discounted payback period.
E) The MIRR method assumes that cash flows are reinvested at the crossover rate.
Correct Answer
verified
True/False
Correct Answer
verified
Multiple Choice
A) 1.61 years
B) 1.79 years
C) 1.99 years
D) 2.22 years
E) 2.44 years
Correct Answer
verified
Multiple Choice
A) A project's regular IRR is found by compounding the cash inflows at the WACC to find the terminal value (TV) , then discounting this TV at the WACC.
B) A project's regular IRR is found by discounting the cash inflows at the WACC to find the present value (PV) , then compounding this PV to find the IRR.
C) If a project's IRR is greater than the WACC, then its NPV must be negative.
D) To find a project's IRR, we must solve for the discount rate that causes the PV of the inflows to equal the PV of the project's costs.
E) To find a project's IRR, we must find a discount rate that is equal to the WACC.
Correct Answer
verified
Showing 41 - 60 of 108
Related Exams